Differences

This shows you the differences between two versions of the page.

--- report:sus [2026/06/13 17:44] – [5.5.5 Use] team1
+++ report:sus [2026/06/13 18:08] (current) – [5.2.4 Materials] team1
@@ Line 82: / Line 82: @@
 Internal parts of the pot are made using 3D printing. The chosen material is Polylactic Acid (PLA), which is a biodegradable plastic made from renewable plants like corn instead of petroleum. Degradation rate is 1 week to 24 months, being the shortest out of all polymers listed. PLA is a sustainable choice because it can be recycled many times without losing its strength [(PLA)].
-To further improve the sustainability of the printed components, the project explores the use of cork-infused filaments based on recent research. These materials combine polymers such as Acrylonitrile Styrene Acrylate (ASA) with cork powder derived from recycled cork waste, allowing natural content to be incorporated directly into 3D printed parts. Studies show that cork can be added in proportions of up to around 15 to 20 % by weight before the material becomes too brittle for effective processing. This approach not only increases the renewable fraction of the product but also creates parts with a texture and appearance that better match cork-based elements of the design. At the same time, these composites can contribute to lightweight structures and offer some insulating properties, supporting both functional and environmental goals. By selecting recycled polymers together with cork composites, the 3D printed elements remain aligned with the eco-friendly objectives of the Screen2Green project while relying on experimentally validated material behavior [(cork_filament_2024)].
+To further improve the sustainability of the printed components, the project explores the use of cork-infused filaments based on recent research. These materials combine polymers such as an Acrylonitrile Styrene Acrylate with cork powder derived from recycled cork waste, allowing natural content to be incorporated directly into 3D printed parts. Studies show that cork can be added in proportions of up to around 15 to 20 % by weight before the material becomes too brittle for effective processing. This approach not only increases the renewable fraction of the product but also creates parts with a texture and appearance that better match cork-based elements of the design. At the same time, these composites can contribute to lightweight structures and offer some insulating properties, supporting both functional and environmental goals. By selecting recycled polymers together with cork composites, the 3D printed elements remain aligned with the eco-friendly objectives of the Screen2Green project while relying on experimentally validated material behavior [(cork_filament_2024)].
@@ Line 189: / Line 189: @@
   * Material Separation: The snap-fit design allows users to easily separate the electronics from the bio-based structure at the end of the 2-year lifecycle.
   * Composting and Recycling: The natural cork base is 100 % compostable. PLA structural parts can be industrially composted or mechanically recycled into new filament.
   * Circular Economy: Electronic components like the ESP32 and relay must be sent to WEEE collection points in Porto. This allows for the recovery of precious metals and responsible waste management.